 The Handy Harry of caulking/sealing kits- Good bonding properties.
- Ideal on natural stone (non-staining).
- Good adherence on tiles, ceramics, porcelain, aluminium, wood, concrete, glazed surfaces, ... without using a primer.
- Mildew and fungus resistant.
- Compatible with the majority of paints.
- Can be used on humid surfaces.
- Almost odourless.
|
|
| TRANS7 - The transparent adhesive or sealant. |
| |
- Sealing of joints between natural stone and other surfaces, porous or non-porous, where risks of stain formation have to be avoided.
- Sealing and bonding of tiles, natural stone, wood, concrete, aluminum, ...
- Sealing of almost all construction materials where a transparent joint is advised.
- Excellent for bathroom, kitchen, wooden floors, ceilings, ...
- Sealing of door chinks.
- For difficult applications with high requirements we advise to use Tec7.
- For applications in combination with glass, UV, ... we advise to use Rock7.
|
| |
| Nature | flexible | | Viscosity | paste like | | Colours | transparent (clear) and translucent (cream) | | Flow | 5 bar / 3 mm / 23°C 160 g/min | | Skin cure | 23°C 50% R.V. 5 minutes | | Tack-free time | 23°C 50% R.V. 40 minutes | | Full cure time | 23°C 50% R.V. | | 24 u - 4 mm | | | 48 u - 5 mm | | | 72 u - 8 mm |
| | Hardness - DIN 53505 | 40 Shore A | | Volume shrinkage after cure | < 2 % | | Tensile strength | 220 N/cm² | | Tear strength - DIN 53507 | ca. 40N/cm² | | Thermal stability | - 30°C up to +95°C
Peak: 155°C max.30 min. | | Adherence | excellent on e.g. tiles, concrete, natural stone,
wood, glass, aluminum, etc.
limitations: PP, PE, PTFE. | | Elongation at break - DIN 53504 | > 350% | | Weatherability | in course of time a discolouring caused by external influences can arise | | Paintability | OK with most water and solvent based paints and lacquers. | | Chemical resistance | good: water, seawater, aliphatic solvents,
oils, greases, diluted organic acids, caustics.
moderate: esters, ketones, aromatics.
bad: concentrated acids, chlorinated solvents. |
|
| |
- Surfaces should be solid, dust-free and degreased. Depending on the nature of the contamination, surfaces should be cleaned with TEC 7 Cleaner and/or FOAM7.
- Apply TRANS7 with mechanic or pneumatic gun (with telescopic plunger).
- Service temperature: +5° C up to + 40° C.
- Finish off joints and clean tools with TEC7 Cleaner.
|
| |
- Packaging
310 ml - cartridges - Packaging
50 ml - blister - Colour:
- Clear = transparent - Shelf life:
Minimum 12 months
|
|
| Novatech at your service ! |
|
|
|
 TRANS7 is ROCK7’s little brother – it can be used on a damp substrate and covered with paint.
|
|
